Tasku Posted January 19, 2023 Share Posted January 19, 2023 (edited) 1 hour ago, wstuart said: EUC world says that my Sherman is charging to 101v. Is would guess that 100.4 is within the acceptable range. Where are you seeing 100.4v? On the charger? Euc world? The calibration of these measurements are within that margin of error. So most likely, the calibration is not perfect for measurement. Sherman should have ability to calibrate, with the display and function keys. First I would measure the charger, see what it shows. Likely 100.8V or very close with digimeter. After full charge you could measure invidual battery packs, but people have made mistakes with this part, attaching the batterypacks in different voltages, or not draining the unit capacitors. So usually checking charger is enough and then using fine tune calibration on shermans end to turn it to proper voltage. You should get instructions from your seller how to use the fine tuning on voltage calibration with the function menus next to display. There was some videos where they browsed and showed the sherman menus, but I forget, maybe wrongway did it? Hope that helps. (edit. if your charger shows proper voltage and wheel does balancing end stage, I would do nothin personally. Tho if it bothers, there is the menus where you can set the voltage correction..) Edited January 19, 2023 by Tasku 3 Quote Link to comment Share on other sites More sharing options...
Popular Post Jon Wall Posted January 19, 2023 Popular Post Share Posted January 19, 2023 6 1 Quote Link to comment Share on other sites More sharing options...
Popular Post Jon Wall Posted January 19, 2023 Popular Post Share Posted January 19, 2023 6 Quote Link to comment Share on other sites More sharing options...
Popular Post Jon Wall Posted January 19, 2023 Popular Post Share Posted January 19, 2023 My comfy Cadillac seat is done. Started with a ergokneeling pad and barge cement. 3 layers of just the right cousion and control combo. 60 miles in the mountains on the msx seat was no good. 6 Quote Link to comment Share on other sites More sharing options...
Popular Post Jon Wall Posted January 19, 2023 Popular Post Share Posted January 19, 2023 6 Quote Link to comment Share on other sites More sharing options...
tombo Posted January 19, 2023 Share Posted January 19, 2023 Hi all. Unboxed my Sherman-S today and it looks incredible. Just curious if the wheel is supposed to give off a high pitched whine at idle? My v12 is mostly silent. Thanks! Quote Link to comment Share on other sites More sharing options...
Tasku Posted January 19, 2023 Share Posted January 19, 2023 1 hour ago, tombo said: Unboxed my Sherman-S today and it looks incredible. Just curious if the wheel is supposed to give off a high pitched whine at idle? I don't think so, maybe record that noise and contact whoever you purchased it from. Add the desc too that you mentioned above. I was thinking maybe your fans are making the sound(bearing), but then again why at idle state.. Anyway your seller should give you instructions that help you. Quote Link to comment Share on other sites More sharing options...
Paul D Posted January 19, 2023 Share Posted January 19, 2023 1 hour ago, tombo said: Hi all. Unboxed my Sherman-S today and it looks incredible. Just curious if the wheel is supposed to give off a high pitched whine at idle? My v12 is mostly silent. Thanks! Mine does not do that. Quote Link to comment Share on other sites More sharing options...
Chester Copperpot Posted January 19, 2023 Share Posted January 19, 2023 32 minutes ago, Paulyd75 said: Mine does not do that. Mine does Quote Link to comment Share on other sites More sharing options...
tombo Posted January 19, 2023 Share Posted January 19, 2023 26 minutes ago, Chester Copperpot said: Mine does I got this back from vendor: Quote At low speeds electric unicycle motors do emit a characteristic rumble, this the frequency of the magnets coming into proximity of the stator. As you increase the rate of rotation, the noise tends to dissipate. This question comes up from time-to-time, but is generally not something to be concerned about. I'll try to post a video later. 1 Quote Link to comment Share on other sites More sharing options...
Paul D Posted January 19, 2023 Share Posted January 19, 2023 Maybe I’m to deaf to hear it? Quote Link to comment Share on other sites More sharing options...
GothamMike Posted January 19, 2023 Share Posted January 19, 2023 Has anyone 3D printed a cover the exposed wires under the shocks? Quote Link to comment Share on other sites More sharing options...
Freeforester Posted January 19, 2023 Share Posted January 19, 2023 (edited) 27 minutes ago, GothamMike said: Has anyone 3D printed a cover the exposed wires under the shocks? Leaperkim have, they call it ‘the stand’. Joking apart, if this is a major concern for your use case, maybe a strategically placed/glued/riveted metal plate within the box indicated would help dissipate/mitigate any sharp impact encountered? I was more concerned with his finger flicking of the capacitors, and in my admittedly very limited understanding of Russian alluding to their lack of support or vulnerability to impact shock, or at any rate gave him sufficient cause to indicate and comment upon (1.27 or so, in the teardown video, last page). Might a dab of silicone or a small piece of supporting foam material fixed beneath the caps be beneficial or alternatively a potential liability? Unfortunately my Russian is more or less limited to “izvanitchye, ya nye gavaru pa Ruski’ - ‘I’m sorry, I don’t speak Russian’! Edited January 19, 2023 by Freeforester Quote Link to comment Share on other sites More sharing options...
MrMonoWheel Posted January 20, 2023 Share Posted January 20, 2023 8 hours ago, tombo said: Hi all. Unboxed my Sherman-S today and it looks incredible. Just curious if the wheel is supposed to give off a high pitched whine at idle? My v12 is mostly silent. Thanks! Mine does that, and when the headlights are turned on its even worse Quote Link to comment Share on other sites More sharing options...
wstuart Posted January 20, 2023 Share Posted January 20, 2023 12 hours ago, tombo said: Hi all. Unboxed my Sherman-S today and it looks incredible. Just curious if the wheel is supposed to give off a high pitched whine at idle? My v12 is mostly silent. Thanks! Mine too. Earlier I had posted that mine sounds like water running through pipes in the walls of my house. It seems like this is normal. Quote Link to comment Share on other sites More sharing options...
MrMonoWheel Posted January 20, 2023 Share Posted January 20, 2023 A dude in my group hit 61.8 indicated, 57 gps on his Sherman S tonight. Absolutely insane. 2 Quote Link to comment Share on other sites More sharing options...
techyiam Posted January 20, 2023 Share Posted January 20, 2023 (edited) On 1/19/2023 at 8:44 PM, MrMonoWheel said: A dude in my group hit 61.8 indicated, 57 gps on his Sherman S tonight. Absolutely insane. It certainly sounds like group ride speeds in the US are climbing. I don't think it is that hard to imagine that more and more riders of 45 mph or less top speed wheels are going to experience cutouts in group rides as they try to keep up with the latest batch of fast wheels riders with more battery and higher top speeds. Edited January 22, 2023 by techyiam 1 Quote Link to comment Share on other sites More sharing options...
wstuart Posted January 20, 2023 Share Posted January 20, 2023 7 hours ago, MrMonoWheel said: A dude in my group hit 61.8 indicated, 57 gps on his Sherman S tonight. Absolutely insane. Was that in San diego? Quote Link to comment Share on other sites More sharing options...
tombo Posted January 20, 2023 Share Posted January 20, 2023 14 hours ago, MrMonoWheel said: Mine does that, and when the headlights are turned on its even worse 11 hours ago, wstuart said: Mine too. Earlier I had posted that mine sounds like water running through pipes in the walls of my house. It seems like this is normal. Thanks for the confirmation guys! I could hear Duf's making the same noise on his livestream74, too. Quote Link to comment Share on other sites More sharing options...
Clem604 Posted January 20, 2023 Share Posted January 20, 2023 I'm just going to leave this here https://miniwheel.ca/products/mini-sherman-s-euc-figure-toy Quote Link to comment Share on other sites More sharing options...
Funky Posted January 20, 2023 Share Posted January 20, 2023 (edited) 8 minutes ago, Clem604 said: I'm just going to leave this here https://miniwheel.ca/products/mini-sherman-s-euc-figure-toy Aww.. I for a split second thought it was smaller version S-S. Because of the title: Mini Sherman - S, before i read finger toy.. Edited January 20, 2023 by Funky 1 Quote Link to comment Share on other sites More sharing options...
GHOSTTE Posted January 21, 2023 Share Posted January 21, 2023 Not my video Quote Link to comment Share on other sites More sharing options...
GHOSTTE Posted January 21, 2023 Share Posted January 21, 2023 Quote Link to comment Share on other sites More sharing options...
RamonatheCat Posted January 21, 2023 Share Posted January 21, 2023 (edited) I put in a preorder for a Sherman S today. Extremely excited - the 6 week wait will be interesting. Edited January 21, 2023 by RamonatheCat 1 Quote Link to comment Share on other sites More sharing options...
Mango Posted January 21, 2023 Share Posted January 21, 2023 Put my order for Sherman S in early November, still waiting for delivery. Container ship docked end of December at port. UPS tracking still says Label Created. Hopefully, my wheel wasn't nicked by some shady logistics employee. The shipping box has the words "Sherman-S" written on it. EUCs aren't the obscure devices they once were a few years ago. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.