DrSney Posted July 1, 2019 Share Posted July 1, 2019 Hello, I just bought a V8 and installed the Android app (v 7.3.3). I cannot figure out how to change the LED lighting effects. There is an "Apply" button in the upper right corner when I choose the active effect (which does nothing). When I choose a different effect there is a "Trans" button which does not do anything at all. Can somebody help me with this issue? Thanks a lot! Link to comment Share on other sites More sharing options...
EUC Custom Power-Pads Posted July 1, 2019 Share Posted July 1, 2019 It only works if you have it in the calibration position. Link to comment Share on other sites More sharing options...
WaveCut Posted July 2, 2019 Share Posted July 2, 2019 you need to transfer scheme into the device Link to comment Share on other sites More sharing options...
DrSney Posted July 2, 2019 Author Share Posted July 2, 2019 The "calibration position" did the trick. Now I can transfer the data into the unit with the "Trans" button. There is no information about this in manual. Link to comment Share on other sites More sharing options...
WaveCut Posted July 2, 2019 Share Posted July 2, 2019 Yeah, that's not covered. Where did you found the hint on that? Link to comment Share on other sites More sharing options...
BarrettJ Posted July 3, 2019 Share Posted July 3, 2019 Is that new? Previously I never had to go into calibration position to set the lights Link to comment Share on other sites More sharing options...
EUC Custom Power-Pads Posted July 3, 2019 Share Posted July 3, 2019 Yes, after the penultimate app-update. In Apri it was just like that, but the transmission lasted forever. Now it works only in the calibration position, but faster. Link to comment Share on other sites More sharing options...
Saryon Posted August 12, 2019 Share Posted August 12, 2019 I was just about to ask the exact same question, together with the firmware update. Putting it in "calibration position" did the trick, thanks a lot! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.