gotnothing Posted October 11, 2019 Share Posted October 11, 2019 I got a new Gotway Tesla replacement board but it looks completely different from my existing one. Does anyone here have an idea of what should go where. I am at a complete loss. Quote Link to comment Share on other sites More sharing options...
Andy Nguyen Posted October 18, 2019 Share Posted October 18, 2019 Hi gotnothing, You can check this photo below. Before, I had the same situation as you so I understand https://drive.google.com/file/d/1CwNNmTRVsbMJZKhog23-4AEAKgZ6EiEb/view?usp=sharing 1 Quote Link to comment Share on other sites More sharing options...
gotnothing Posted October 18, 2019 Author Share Posted October 18, 2019 Thanks very much. did you end up having to add more glue on the wires after putting them back in? Quote Link to comment Share on other sites More sharing options...
Andy Nguyen Posted October 24, 2019 Share Posted October 24, 2019 Basically, Gotway they use rubber glue. But I don't have, so I use Silicon glue but everything is OK. I am sure for doing so much. By the way, note that when working with the mainboard, discharge all the electricity in the mainboard and then connect the power cord (I have damaged two mainboards after changing the tires). Exactly damaged Hall Sensor inside maiboard => You can find information about it below https://drive.google.com/file/d/1yQ10olAWwDGHg4dclsT_c5zrTRETt7at/view?usp=sharing https://drive.google.com/file/d/1E6EexMpMhV2FCZ79bGngJFlJLmhUs-YA/view?usp=sharing Quote Link to comment Share on other sites More sharing options...
Chriull Posted October 24, 2019 Share Posted October 24, 2019 Hi @Andy Nguyen - pictures and videos can here be better posted from other providers than google: Quote Link to comment Share on other sites More sharing options...
gotnothing Posted October 24, 2019 Author Share Posted October 24, 2019 How do I go about discharging electricity on the mainboard? Quote Link to comment Share on other sites More sharing options...
meepmeepmayer Posted October 24, 2019 Share Posted October 24, 2019 6 hours ago, gotnothing said: How do I go about discharging electricity on the mainboard? Disconnect the battery Switch the wheel on. The wheel will turn on and balance for a second until the residual energy is drained from the capacitors and the wheel is "dead". When you reconnect the battery at the end, do it quickly and without fuss. This reduces the chance of a bad spark (due to the voltage difference between the full battery and the empty capacitors). 1 Quote Link to comment Share on other sites More sharing options...
Andy Nguyen Posted October 25, 2019 Share Posted October 25, 2019 Hi @Creole, Thank you for your interest, I will pay attention to this issue. Quote Link to comment Share on other sites More sharing options...
Andy Nguyen Posted October 25, 2019 Share Posted October 25, 2019 Hi @Chriull, Thank you for your interest, I will pay attention to this issue. Quote Link to comment Share on other sites More sharing options...
gotnothing Posted October 25, 2019 Author Share Posted October 25, 2019 Awesome. Didn't think of doing that. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.