AmunLekan Posted September 14, 2019 Share Posted September 14, 2019 @Vik's @enaon @Decio Bernardo… Hi, yes this post was forever ago. i'm having that same problem and wondered if there was a way to reestablish connection with motor. my story is...bought new Schwalbe tyre. the dam thing came off, the inner tube ballooned and expanded the unit (outward) - the wheel ceased and the inner shell cracked. fast forward now, swapped out the parts and this single yellow either side of the machine flashes. or full green lights come on, or red light depending on angle of wheel at start up. but...no wheel spinning in anycase what can I do please...anyone? thanks Quote Link to comment Share on other sites More sharing options...
enaon Posted September 15, 2019 Share Posted September 15, 2019 (edited) In my case it was my mistake, it seems that somehow I managed to damage the board while working on the wheel. I soldered in a new resistor and all is ok. The board is screwed to the inner shell, maybe you should inspect it for damage Edited September 15, 2019 by enaon 1 Quote Link to comment Share on other sites More sharing options...
Vik's Posted September 30, 2019 Share Posted September 30, 2019 On 9/15/2019 at 2:45 AM, enaon said: In my case it was my mistake, it seems that somehow I managed to damage the board while working on the wheel. I soldered in a new resistor and all is ok. The board is screwed to the inner shell, maybe you should inspect it for damage ... ^What he said. @AmunLekan, I would definitely looked over the controllerboard to see if there are any irregularities there. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.