Jump to content

Lighting Mods: Thin LED strings available :)


daskalos

Recommended Posts

Looks nice! Is that waterproof? I had that glow wire all over my burning man bicycle but I dont think they were waterproof back then.

yep:) Just make sure that the exposed ends or connections are covered with water resistant/proof tapes :)

Link to comment
Share on other sites

Nice clean install!

I did something similar on a scooter (strips with spaces between lights, couldn't cut them) The wiring was complex: glad I had all the available room inside the scooter fairings, I'm impressed you did it in a compact space!

scoot lights.jpg

Link to comment
Share on other sites

actually the Led wire is very thin (a little thicker than most earphone wires) making it ideal for compact areas. It is connected to a compact controller, giving it  3 lighting modes (always on, blinking, blinking+ ) and powered by two AA batteries.

It's not as bright as normal led strips. Lumens is about the same or a little higher than Glow Sticks, a bit low, but enough to be seen by motorists, bikers, and pedestrians at night.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...