Charles McLean Posted March 1, 2018 Share Posted March 1, 2018 If anyone needs a 3D Printed Mud Guard for a Gotway MSuper V3S+ I can confirm that Dwayne at 3D HUBS can print you one that fits perfectly. I've ordered several from Dwayne and they all fit and work perfectly! Absolutely no mud or splatter whatsoever after installation of these mud guards. You'll notice that I added some "U" shaped clips on the bottom to prevent the mud guard from sliding down while riding over bumps, but they are not necessary ... just something I did for my own peace of mind. Here are the links to Dwayne's 3D HUBS website (both of them) https://www.3dhubs.com/users/dmyers7https://www.3dhubs.com/service/32091 Also attached is the *.stl file originally produced by Tillman that will allow Dwayne to print the part. Check out the pics! Enjoy! 1x-GW18V3_Mudguard_Klingon-Edition_original-54.6x92.4x180.6mm.stl Link to comment Share on other sites More sharing options...
yourtoys7 Posted March 3, 2018 Share Posted March 3, 2018 I have the same one, I only use it when it rains/ whet road, other wise I prefer the look without. Link to comment Share on other sites More sharing options...
Charles McLean Posted March 3, 2018 Author Share Posted March 3, 2018 3 hours ago, yourtoys7 said: I have the same one, I only use it when it rains/ whet road, other wise I prefer the look without. Yeah, I only use it in the rain. Otherwise, I keep it off, especially when I'm riding on trails. But, it works perfectly in the rain! Link to comment Share on other sites More sharing options...
LaRoueDeSecours Posted March 24, 2018 Share Posted March 24, 2018 Hi. EU GUY also proposed that one, see picture. Quite efficient and better look. Link to comment Share on other sites More sharing options...
.thumb.jpg.5f9a85b2613592dd03661b336d6b051d.jpg)
Recommended Posts
Archived
This topic is now archived and is closed to further replies.