Mten3- alarm on start-up.

[paolinger]

Good morning.  My mten3, when started, oscillates slowly back and forth then emits the alarm signal.  I have tried numerous calibrations without success.  I'm afraid it's a problem with the gyroscope on the motherboard.  Do you have any suggestions?

Edited October 2, 2023 by paolinger

[Paradox]

Does your battery charge to 100%?

[paolinger]

Yes 100%

[Paradox]

6 minutes ago, paolinger said:

Yes 100%

Some Begode wheels can be reset having the wheel free spin until cut out.  Some have been reset holding down the power button for 30 seconds.  I hope you find the fix for your wheel.

[paolinger]

This connector don't seems to have a beautiful color.

[paolinger]

Good morning. I'm trying to replace the motherboard. Is there any special procedure other than connecting everything properly? The wheel starts immediately at high rpm and then goes in tilt..

[Paradox]

58 minutes ago, paolinger said:

Good morning. I'm trying to replace the motherboard. Is there any special procedure other than connecting everything properly? The wheel starts immediately at high rpm and then goes in tilt..

 I heard this happens on some wheels if you do not connect the wires in the correct way.  Did you take pictures? 

[paolinger]

    Ho seguito queste informazioni

Edited October 11, 2023 by paolinger

[paolinger]

The problem is that the connectors are from the old MB and may not keep the same direction

[paolinger]

I finally managed to revive my mten3 by connecting the cables appropriately. Everything seems to be working fine.