Lingegner Posted September 6, 2022 Share Posted September 6, 2022 Hi all guys, thanks for your support, I’ve a problem: yesterday I kick my display cable.. I open my ninebot cause it immediately shut off… I found the display cable disconnecTed from: controller and display i ve reconnected the cable but the rear led blinking and no signal in the display. I’ve replaced the cable but nothing has changed. so I’ve : display off rear led blinking on the controller I’ve seen 2 led. On : one is green and one is red. so to do diagnosis what can I do ?…. my idea was to give 3,3 5 volt to display and check if it’s ok( could the display cable ko). my second idea was to try to connect the g30 via bluthoot and check for errors… suggestions?… Lingegner Quote Link to comment Share on other sites More sharing options...
litewave Posted September 7, 2022 Share Posted September 7, 2022 You posted this in the General Electric Unicycle Forums. I believe the Ninebot G30 is an electric scooter, so this topic probably belongs in: Non-Self-Balancing PEVs > e-Scooters @meepmeepmayer can you please assist? 1 Quote Link to comment Share on other sites More sharing options...
meepmeepmayer Posted September 7, 2022 Share Posted September 7, 2022 @litewaveOk, if you ask Moved it. @LingegnerNot sure if you will find much help about an escooter on this forum (about electric unicycles), but maybe someone knows the answer. 1 1 Quote Link to comment Share on other sites More sharing options...
beauwayne7 Posted September 15, 2023 Share Posted September 15, 2023 Hello, did you end up finding out the problem? I am also having the same issues. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.