Ori Haberman Browns Posted April 2, 2019 Share Posted April 2, 2019 My original ks charger burnt out. I ordered a new charger (not original from ks) and it puts out 67.2V between pins 1 and 2. When I plug it in the wheel doesnt charge. When I used my friends ks charger last week the wheel did charge. My guess is the charger is putting the voltage out through different pins that the wheel is expecting. Could anyone measure the voltage between the pins (theyre marked 1-2-3 on the connector) and tell me the voltage between each one? ThankS Link to comment Share on other sites More sharing options...
Ori Haberman Browns Posted April 2, 2019 Author Share Posted April 2, 2019 nevermind, I see it says on the original charger itself. you can close this thread. Thanks! Link to comment Share on other sites More sharing options...
esaj Posted April 2, 2019 Share Posted April 2, 2019 8 minutes ago, Ori Haberman Browns said: nevermind, I see it says on the original charger itself. you can close this thread. Thanks! Careful though, the pins are numbered in reverse order in my original KS16S charger vs. what it says in the back of the charger. As in, if you look the connector from the front, pin 3 is on the left and pin 1 on the right, in the picture behind the charger they're the opposite. The numbers are still "right", ie. 3 is negative and 1 is positive. I measured 67.409V between the pins. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.