ursi Posted June 13, 2023 Share Posted June 13, 2023 I can't get the trolly handle to close, regardless of where I position the seat, and with application of considerable force. What could be the issue? Quote Link to comment Share on other sites More sharing options...
ursi Posted June 14, 2023 Author Share Posted June 14, 2023 (edited) So turns out the problem was the center velcro. It added just enough height in the middle to make the handle not close. By removing that and using smaller patches of velcro off to the side, I was able to get the handle to lock down. Edited June 14, 2023 by ursi 1 Quote Link to comment Share on other sites More sharing options...
sWiFt Posted June 16, 2023 Share Posted June 16, 2023 (edited) If anyone else struggling; 1) Raise the handle 2) Fit the seat against the handle 3) Lower the handle together with the seat in a coupled position. The handle should then lock into place, hold the seat with one hand and flip the handle lock, it should pop up easily if you done stuff right. Congratulations, you are an expert! Now remove the protective cover from the pre-applied velcro tape, and do 1-3 again (in the same manner). It should end up perfect - If you struggle to find a proper fit an advice is to have a gap in the rear section of the seat, it shouldnt be fitted against the shaft profile but rather aim against the top grip part, which touches the front inner side of the seat. The other space is wiggle room. Good luck! Edited June 16, 2023 by sWiFt 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.