RoboFixIt Posted April 1 Share Posted April 1 (edited) Tried to change the bearing grease to marine grease by Moly and it doesn't sound very good, what do you think? Tried putting a lot vs a little and it didn't make much of a difference. I read online not much is really needed and too much can cause more issues but I think over all I'm just going to stick with regular bearing grease because it's just too much trouble, It sounds like there's a lot more friction and the bearings are probably going to over heat and lock up because Moly is too thick and sticky for the job. If you have a better idea let me know! Thank you! Edited April 1 by RoboFixIt Quote Link to comment Share on other sites More sharing options...
Dan Cobar Posted April 1 Share Posted April 1 Any grease is better than no grease. And remember, the bearings in a wheel are being run at much lower speeds than the bearings were designed for. Good quality bearings aren't that expensive, and if you get the ones with rubber seals, they should come with an appropriate grease in them. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.