Vivianjiangster Posted March 14, 2016 Share Posted March 14, 2016 Our engineer shows you how to change your hoverboard battery. The video: How to change your hoverboard battery The specific steps as below: Step 1: Open the bottom cover. Unscrew 9 screws on the battery side. Take a photo to ensure you will place the cables back in the correct way. It is better to put the cables in the original way. There are some different ways. So it is better to take a picture before starting to change to ensure you remember how to put them back correctly. Step 2: Unscrew 4 screws and take off the battery cover. It is better to take a photo too. Step 3: Disconnect the connector (XT60) of battery. (Standard: Only 1 connector) Plus: If the battery of your board has 2 connectors. It is not standard. But don’t worry. You can also use our Samsung battery. Please contact us to buy a conversion cable. Step 4: Take out the old battery and connect the new battery to the connector. Don’t worry about the positive and negative electrode. It is set in the connector. You just need to connect them well. Step 5: Turn on the power to test if your hoverboard can work. Step 6: If the testing is ok, Place the new battery in the right position. Place the cables exactly the same as the photo you took at the beginning. Screw battery cover. Step 7: Put the bottom cover back and screw well. Pay attention to the cables. Don’t screw them or put them outside the shell as the below pictures. Enjoy your hoverboard again with the safety battery! Any question, please contact our hot line: 1-818-3578677 Hoverboard REPAIR SERVICE CENTER IN LOS ANGELES 3731 B San Gabriel River Pkwy Pico Rivera, CA 906601-818-3578677 Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.