Kizechs Posted November 23, 2017 Share Posted November 23, 2017 After dad fell off the hoverboard, it charges, but doesn't sense weight. It's been recalibrated several times and still doesn't sense weight. I haven't looked inside yet, I wanted to know the best odds of a bad sensor or main board versus bad connection or the like. Link to comment Share on other sites More sharing options...
Hunka Hunka Burning Love Posted November 23, 2017 Share Posted November 23, 2017 If you take it apart, check the rubber sensor pads to make sure they aren't binding. On mine I believe there's a little tab that when the pad is stepped on slides into a sensor telling the board to activate. Link to comment Share on other sites More sharing options...
SWEGWAY-PRO Posted December 7, 2017 Share Posted December 7, 2017 Hi @Kizechs, It could potentially be that one of your gyro sensors have gone. When you press the pads, does it beep at all? When you 'recalibrate it' does only one side of the LED's flash and not the other? These are typical symptoms of a failed gyro board and unfortunately it may be the case that you'd have to replace this. Hope this helps! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.