Jump to content

Another Msuper 3 cutout in Belgium


Recommended Posts

After @Puce and I enjoying the oscillation issue, a 3rd Belgian wheeler fell the same day as us. 

However, his wheel was manufactured before the dreadful firmware version, and there was no oscillation before his cutout. 

See the wheel behavior after the fall: https://youtu.be/_aOunvpDM2I

Does this behavior ring a bell to anyone? Looks like a previous inmotion v8 issue I had seen, where a magnet had fallen off inside the motor. 

Link to comment
Share on other sites

47 minutes ago, em1barns said:

After @Puce and I enjoying the oscillation issue, a 3rd Belgian wheeler fell the same day as us. 

However, his wheel was manufactured before the dreadful firmware version, and there was no oscillation before his cutout. 

See the wheel behavior after the fall: https://youtu.be/_aOunvpDM2I

Does this behavior ring a bell to anyone? Looks like a previous inmotion v8 issue I had seen, where a magnet had fallen off inside the motor. 

Again i would say "normal" motor failure.....hall sensor...totally loose wheel nuts....or board gyro defect...

Not the "oscillating " fault....

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...