Tishawn Fahie Posted August 13, 2016 Share Posted August 13, 2016 I'm pretty good with soldering but not sure where to start - I already purchased a USB port. I know how to take apart my wheel and get to the mother board. Any Ideas anyone where I should begin - Which part of the board I should solder wires. Basically I want to be able to charge a phone or camera etc... Any help is appreciated it. Link to comment Share on other sites More sharing options...
electric_vehicle_lover Posted August 13, 2016 Share Posted August 13, 2016 Buy the MicroWorks voltage converter 60v->12v. Then add the USB port board that can have the power input from the 12v. I used the 60v-12v module on the RGB LED mod for EGG EUC and documented. You even configure the module to output other voltages like I did for 5v output. See here: https://github.com/EGG-electric-unicycle/documentation/wiki/MicroWorks-30B4-controller-board-RGB-LED-strip Link to comment Share on other sites More sharing options...
Tishawn Fahie Posted August 13, 2016 Author Share Posted August 13, 2016 Thank you so much. I will check this out. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.