Popular Post ScottyWheel Posted October 2, 2021 Popular Post Share Posted October 2, 2021 So I got water I side my start button and it konked out my wheel. eWheels sent me a replacement button gratis (!!) Hooked it back up and it works like a charm. However I did encounter one very frustrating aspect of the reassembly. When putting the light/button housing back on the wheel, one side would not slide all the way to the bottom. At first I thought it was the wires getting in the way, then thought it was the rubber seal, turns out it was none of that: Make Sure the inside screws holding the light are ALL the way tightened, because that is also where the housing fits snugly to the wheel frame. If the screw is even slightly out, the housing will not mate. Hope this helps someone in the future! Drove me crazy for the last hour. 4 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.