airwheel 14 inch rubbish

[terry53]

installed another mainboard out of the two wheel job which looks identical and you push start button and it goes but wont stop as motor dosent wont to calibrate maybe...uspecting its wired wrongly but looks ok..any ideas thanks no app for these ?

[Mark13i]

9 hours ago, terry53 said:

installed another mainboard out of the two wheel job which looks identical and you push start button and it goes but wont stop as motor dosent wont to calibrate maybe...uspecting its wired wrongly but looks ok..any ideas thanks no app for these ?

the opposite direction of wheel rotation blocks the calibration (its result is not saved).  Make sure that the direction is correct - maybe you reversed the order of the motor power cables.

[Mark13i]

Important information!  

With three power cords, you can make six combinations of order;  

1 combination - wheel does not turn,

1 combination - wheel turns OK,

4 combinations - wheel turns but the motor consumes a lot of current (risk of burning MOSFETs !!)

Edited July 14, 2021 by Mark13i

[The Fat Unicyclist]

On 7/12/2021 at 4:04 PM, terry53 said:

installed another mainboard out of the two wheel job which looks identical and you push start button and it goes but wont stop as motor dosent wont to calibrate maybe...uspecting its wired wrongly but looks ok..any ideas thanks no app for these ?

Hi Terry, 

Did you want to post a photo of the control board (including connections)... Someone may be able to comment further based on that.