PLEASE_DELETE Posted May 1, 2021 Posted May 1, 2021 (edited) Deleted. Edited March 17 by PLEASE_DELETE Quote
Boris Lämpel Posted May 1, 2021 Posted May 1, 2021 Q1: the shell is made to fit for both sides (left and right). So the holes have to be at the front and back. The screws there fit into the metal piece of the trolley. Q2: Sadly You have to open the Nik on both sides, unscrew everything (also the screws behind the RGB LED) lest the screws atached to the pedal hanger. Then You turn the wheel on the side with the motherboard, so that the side with batteries only is facing upwards. Then You remove that inner shell (unscrew screws at pedal hanger), but only on that side. For removing the inner shell You have to unplug the batteries and remove them and every tape. Now you can remove the inner piece (trolley, lift switch, backlight) by removing only 2 wooden screws there. This is only possible from one side. If You are there, You can also remove the layer showing GW, so that the backlight is red only and better visible. Quote
PLEASE_DELETE Posted May 1, 2021 Author Posted May 1, 2021 (edited) Deleted. Edited March 18 by PLEASE_DELETE Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.