Jump to content

"Veteran" New brand of high performance EUC's


Recommended Posts

fill the back of them with rtv as you screw them together. Generic plugs tend to have meager strain relief. Be thankful you didnt go neutrik or you'd never bother with another brand. :)

Edited by ShanesPlanet
Link to post
Share on other sites
  • Replies 990
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Popular Posts

Hopefully they didn't take the Glue Gun Guy and his brother the Solder Blob Guy.

The guys who don't ride soft mode to the full extent will tell you comfort, and while this is true, this is only barely scraping the surface of really "why soft mode"?   ... and mind you, no

Demo wheel is out and about in NYC.  Initial impressions from photo teardowns indicate similar build design as Gotway wheels; Axle nut/design is identical, Pedal hangers are the exact same width as Go

Posted Images

For dayltime running lights I'd ideally like something  with an outer ring or line of white LEDs that don't flash and are just for visibility, more like on the V11, as orange can also get me into trouble here. Has anyone found anything of the sort?

Link to post
Share on other sites

Just received mine.  Do you guys notice an initial vibration when pulling away, more so than Gotway I would say?  

Struggling to determine what pads to use.  The stock ones seem to require more upper body lean perhaps due to location.  

Didnt realise that pressing the power button turns the rear light off.  

Link to post
Share on other sites

Nice if they review the controller panel. It looks like they redid the mould for that part.
The red buttons are a bit cheesy though, they already have the tail light in that fashion, I hope they stop it there.

Looking forward to seing the evolutions.

Edited by null
Link to post
Share on other sites
5 minutes ago, null said:

Nice if they review the controller panel, but red buttons is a bit cheesy..

Probably more durable than the old design and hopefully water resistant 

Link to post
Share on other sites
On 12/28/2020 at 7:51 AM, null said:

Nice if they review the controller panel. It looks like they redid the mould for that part.
The red buttons are a bit cheesy though, they already have the tail light in that fashion, I hope they stop it there.

Looking forward to seing the evolutions.

Where do you see info on the new panel?

Link to post
Share on other sites
1 hour ago, Kekafuch said:

Where do you see info on the new panel?

@Kekafuch, there was this video shown on Facebook: https://www.facebook.com/1290045551/videos/10218589379987609/

Link to post
Share on other sites

Anyone knows which motor-cable goes where on the motherboard?

I've tried google, mailing Leaper Kim, asking Marty and of course the seller, but I haven't gotten any answers. 

Link to post
Share on other sites
28 minutes ago, Espen R said:

Anyone knows which motor-cable goes where on the motherboard?

I've tried google, mailing Leaper Kim, asking Marty and of course the seller, but I haven't gotten any answers. 

I took a pic before I swapped my tire , hope it helps

boardpic.jpg

Link to post
Share on other sites
9 hours ago, Willy510 said:

I took a pic before I swapped my tire , hope it helps

boardpic.jpg

You could just connect the three to each posts. Then turn on the wheel. If anything is abnormal, just swap 2 of the wires and it will operate like normal. 

Link to post
Share on other sites
13 hours ago, Willy510 said:

I took a pic before I swapped my tire , hope it helps

boardpic.jpg

Thank you so much! 

4 hours ago, Kekafuch said:

You could just connect the three to each posts. Then turn on the wheel. If anything is abnormal, just swap 2 of the wires and it will operate like normal. 

Good to know! Thank you for the info

Link to post
Share on other sites

 

41 minutes ago, DragonFZ said:

While the exact cause of what happened is under investigation, based on the evidence on hand it was a Gotway 100V Wheel (the battery on the MTen3 is different). Other manufacturers in this shipment, such as Inmotion, King Song, Veteran, have more sophisticated battery BMS cell monitoring, casings, battery manufacturing practices to minimize the likelihood of this type of event.  

All Veteran would need to do is release one or two solid lower-tier/more affordable/bit lighter models, for example similar category to the MSP/RS (so still 100v but closer to the ~$2k price-point and sub-60 lbs) in addition to their flagship Sherman--and then how long before the major distributors such as ewheels might decide Gotway just isn't worth the never-ending series of assembly/QA issues and drop them altogether? (Obviously they wouldn't have done that when Gotway was the only high-speed, 100v option.. but the existence of Veteran and success of the Sherman changes that, if only they also made a more middle 100v offering to fill the gap between the Sherman on one hand and the highest-end InMotion & King Song wheels on the other.)

Edited by AtlasP
Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...