gotnothing 3 Posted October 11 I got a new Gotway Tesla replacement board but it looks completely different from my existing one. Does anyone here have an idea of what should go where. I am at a complete loss. Quote Share this post Link to post Share on other sites
Andy Nguyen 1 Posted October 18 Hi gotnothing, You can check this photo below. Before, I had the same situation as you so I understand https://drive.google.com/file/d/1CwNNmTRVsbMJZKhog23-4AEAKgZ6EiEb/view?usp=sharing Quote Share this post Link to post Share on other sites
gotnothing 3 Posted October 18 Thanks very much. did you end up having to add more glue on the wires after putting them back in? Quote Share this post Link to post Share on other sites
Andy Nguyen 1 Posted October 24 Basically, Gotway they use rubber glue. But I don't have, so I use Silicon glue but everything is OK. I am sure for doing so much. By the way, note that when working with the mainboard, discharge all the electricity in the mainboard and then connect the power cord (I have damaged two mainboards after changing the tires). Exactly damaged Hall Sensor inside maiboard => You can find information about it below https://drive.google.com/file/d/1yQ10olAWwDGHg4dclsT_c5zrTRETt7at/view?usp=sharing https://drive.google.com/file/d/1E6EexMpMhV2FCZ79bGngJFlJLmhUs-YA/view?usp=sharing Quote Share this post Link to post Share on other sites
Chriull 3,691 Posted October 24 Hi @Andy Nguyen - pictures and videos can here be better posted from other providers than google: Quote Share this post Link to post Share on other sites
gotnothing 3 Posted October 24 How do I go about discharging electricity on the mainboard? Quote Share this post Link to post Share on other sites
meepmeepmayer 9,869 Posted October 24 6 hours ago, gotnothing said: How do I go about discharging electricity on the mainboard? Disconnect the battery Switch the wheel on. The wheel will turn on and balance for a second until the residual energy is drained from the capacitors and the wheel is "dead". When you reconnect the battery at the end, do it quickly and without fuss. This reduces the chance of a bad spark (due to the voltage difference between the full battery and the empty capacitors). Quote Share this post Link to post Share on other sites
Andy Nguyen 1 Posted October 25 Hi @Creole, Thank you for your interest, I will pay attention to this issue. Quote Share this post Link to post Share on other sites
Andy Nguyen 1 Posted October 25 Hi @Chriull, Thank you for your interest, I will pay attention to this issue. Quote Share this post Link to post Share on other sites
gotnothing 3 Posted October 25 Awesome. Didn't think of doing that. Quote Share this post Link to post Share on other sites