Jump to content

ACM still stuttering after board tightened.


Breadsticks

Recommended Posts

 

So I tightened the board and now there’s much less play between forward and reverse, but when I put weight on a pedal and then remove a bit of weight to reposition it freaks out big time. Haven’t seen it shake this bad ever. 

Its the acm that chooch stabbed a guy on, so who knows what hell its been through.

 

This last crash was at full speed (only 22). It rides fine but I’m afraid as all fuck to go fast and hit a bump

Link to comment
Share on other sites

Your symptoms can only be caused by three things:

  1. Loose control board
  2. Loose pedal-arm to shell mounts (six screws on each side of the shell
  3. Loose axle nuts

Give the hell that Chooch puts his wheels through (and I know he used to jump the ACM like crazy), my money is on loose axle nuts.

Link to comment
Share on other sites

How do I tighten them?!

 

id take a video but I only have one arm so it’s impossible. I have a friend take a vid later. So do I take the side panels off or the entire shell? The shell screws seem a bit fuckey. Stripped and whatnot.

a new case cost as much as the wheel so fuck that. Helllppppp

Link to comment
Share on other sites

27 minutes ago, Breadsticks said:

How do I tighten them?!

 

id take a video but I only have one arm so it’s impossible. I have a friend take a vid later. So do I take the side panels off or the entire shell? The shell screws seem a bit fuckey. Stripped and whatnot.

a new case cost as much as the wheel so fuck that. Helllppppp

 

 

Link to comment
Share on other sites

46 minutes ago, Breadsticks said:

I just watched that. I only have a left arm and don’t think I’m physically capable of doing it. Here’s a video.

https://imgur.com/a/kBQZmys

Hopefully you can find someone who can help. Not sure how else I can help.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...