Jump to content

v5f innertube


Tsavage
 Share

Recommended Posts

Hi i was looking for one but couldn't find one fast so I fit a inner tube with a straight valve and made a spacer out of a foam pads that you stick on to the bottom of a table leg to stop it wobbling they are about 10 mm thick and 30mm diameter I put that on the valve before pushing it through the hole so it stops the valve from sticking out as far and it's still long enough to get the pump on it and it is working fine and it doesnt catch the ks all the time like the angled one did

Link to comment
Share on other sites

  • 2 weeks later...

Thanks for response, found a load on amazon the right size with the angle on them. However i needed to melt out some of the bottom part of the inside of the case facing the wheel as it was catching, quite easy to do.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...