cbgti Posted August 18, 2018 Share Posted August 18, 2018 I don't understand how to calibrate the trolley of my KS18L... It worked very well with the Firmware 1.06 : 0 fail in 30 tests. Then I made the update (directly from Fw 1.06 to Fw 1.10). O have to calibrate the wheel, but I don't understand how... I have to place the wheel "horizontally without lifting it". There are some beeps. After, I have to lift it (I think), but I don't know when... My lift sensor system don't work now. Can someone give me a full explanation please? ? PS: I have the Android App v1.50. Quote Link to comment Share on other sites More sharing options...
US69 Posted August 18, 2018 Share Posted August 18, 2018 28 minutes ago, cbgti said: I don't understand how to calibrate the trolley of my KS18L... It worked very well with the Firmware 1.06 : 0 fail in 30 tests. Then I made the update (directly from Fw 1.06 to Fw 1.10). O have to calibrate the wheel, but I don't understand how... I have to place the wheel "horizontally without lifting it". There are some beeps. After, I have to lift it (I think), but I don't know when... My lift sensor system don't work now. Can someone give me a full explanation please? ? PS: I have the Android App v1.50. Look here, please: 3 Quote Link to comment Share on other sites More sharing options...
cbgti Posted August 19, 2018 Author Share Posted August 19, 2018 Thanks a lot @US69 ! It's works most of the time for me... 1 Quote Link to comment Share on other sites More sharing options...
Jean eRide.ie Community Posted October 26, 2018 Share Posted October 26, 2018 (edited) Thanks for the video, Since I replaced the handle bars for the improved version, the sensor stopped working. I follow the video, but when it is time to lift it, instead of not spinning as on the video, mine spins and the test finishes straight away, earlier than on the video. After doing the test, a warning appeared on the left of the speedmeter, tapping it shows the error description. See pictures attached. I'm checking with the supplier, I'll keep this updated. EDIT: I think I know why, I definitely did over-tighten the sensor screw... I didn't know it had to not be tight as explained here (watch the video on the quoted message by @Circuitmage: Edited October 26, 2018 by Jean Dublin Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.