Jump to content

Any idea for a bricked control board


Recommended Posts

Last time I bricked my ninebot mini by updating firmware.

I ordered new control board from the manufacturer and fixed my ninebot.

Now I have a bricked "cup error" control board in my hand.

Anyone have good idea to deal with it?

I have roughly test the port connecting control board to BLE board. There are serial TX RX pins power supply pin ect. The FETs on board should  be good to use. So are the driver modules.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...